Vaping Non-subohm At 20+ Watts

I purchased my smok vct a1 at a local vape shop and was told the coils cannot be rebuilt another vape shop had the do it yourself kits for this specific sub ohm tank, the factory coil is a single, but the diy is a dual that tests at .41 my itaste mvp3 loves the diy, the flavor is amazing and so is the cloud, to the smoketek fans out there i highly recomend trying the diy, after watching the build video on youtube  

Just curious what wattage you guys are comfortable with. I just got my Itaste mvp3.0. I have the Kanger Subtank Nano with a .5 ohm occ. The mvp recommends 25-30 watts for that. But the coil itself says 15-30 watts. Kind of confusing. Anyway I keep mine between 15-20 watts. Anything more heats the tank up too much, like I can feel the heat on my lip.

I just picked up a Kanger Genitank Mega also, haven't tried it yet but it came with 1.8 coils, so I'll probably start at about 6-7 watts and go from there.

I love this thing, so far very happy with my purchase, hopefully it holds up for a long time. I guess just want to see if I'm doing everything safely.  

So....been vaping for 6 years.

For the last couple years I was using a Reo with an RBA at .5 ohms and was going through about 12-15ml a day. A friend of mine let me try his sub ohm tank a few weeks ago and I was hooked! The flavor was better than my Reo/RBA setup and the vapor was OMG.

Anyways, I've since bought a couple of sub ohm tanks with an IPV2 Mini, then graduated to a Goliath RTA with an SX Mini M Class. Using the Goliath with a .44 ohm dual coil at 30 watts on the SXM and I'm going through anywhere from 25-35ml a day! This just seem excessive....

Can anyone recommend an RTA that would use less juice but still give me a lot of airflow and flavor? I'm not all about the vapor, although I do enjoy it.

I'm guessing that if you want lots of airflow (I'm a direct lung inhale kinda guy) and a warm, full vape you pretty much have to vape at higher wattages/lower ohms and therefore use excessive amounts of juice...just wondering if anyone else has had a similar experience and has successfully cut down their juice consumption.

FYI, I DIY my juice so cost is not really an issue...I'm a bit concerned that using this much juice every day just can't be good for you.  

Hi al I was wondering what would be my best bet to get the must flavor out of my juice. What I have is a eleaf 50w I am useing a kanga subtank mini . I do 5 wrap coils with 26 g kantal . My eleaf reads .6ohms. I vape at 17 to 22 watts depending on the air flow I am useing. Any suggestions on hardware or wires any suggestions will do to get the must flavor .  

So, like everyone else, I have my preferred juice (extremely complex DIY with all NET flavors) and my preferred all day driver (Subtank Nano and an Ego One 1100 mah battery). It's performed GREAT. I use prebuilt OCC coils and I rebuild those coils, too. Most of the time, they work just like they do with any other rig... they hiss (like all atomizers) and pop and crackle... part of the nature of sub ohm vaping (I use the 0.5 ohm heads, btw).

Once in a while, the stars align and the vaping gods smile down, and NO popping. I have to actually fire the device for a while to make sure it works. The telltale hiss is there, just no popping. It's happened with prebuilt coils and coils that I've rebuilt. Not sure what the deal is, but the vape is SOOOOO much better.... flavor seems improved too, but it might be mental.

Whatever the case, thank you, vaping gods, stars, fates, or whatever. That occasional perfect coil is nice.  

I'm almost two years into vaping and it has been great.

I've been using a VW Ehuge 35 watt 26650 mod with a Kanger Subtank. Its huge and heavy but the battery lasts a long time. Also been using an Innokin Coolfire 2 with a Gladius tank.

Figured it was time to upgrade. Been watching several review videos to see whats out there. A lot of new sub ohm tanks and they all seem pretty good.

I've never had a box mod and figured it was time. Bought a Cloupor T6 recently to put my Subtank on. The T6 is supposed to be a 100 watt device. The Kanger coil only goes to 30 watts so no big deal there.

I really like the T6. Pretty small for a 26650 mod. Surface is slippery though, need to get a wrap for it. Butons are nice any clicky. The battery cover has magnets which is nice, no screw driver needed. Feels solid and the internals are clean. Its thick and the 25mm Subtank fits nicely on it.

Recently after watching some videos, I came across a new kinda unknown Sub Ohm Clearo. Its the Freemax Starre Sub Ohm. .5ohm or .25ohm coils. Mine came with the .5ohm. The .5ohm is rated 20-60 watts and the .25ohm is rated 20-100 watts. Reviewers were all impressed with the vapor and taste of this device. So I ordered one.

Wow, OMG, this Freemax Starre rocks. Blows away my Kanger Sub Tank in vapor production and flavor. Holds 5ml and the air holes are huge. Surgical Stainless Steel and Surgical Cotton used in the coil. Amazing.

After some more research, I discovered the Cloupor T6 really doesn't put out 100 watts. Well, that makes sense as its only a single battery device.

So went to the local vape shop today and bought a Sigelei 150 watt to put the Freemax Starre on. Will order some .25ohm coils soon.

Lovin the Sigelei so far. Magnets on battery cover, comes with a silicone gel case, nice clicky buttons, takes 2 18650. Its taller and wider than the T6 but not as thick. One thing it lacks that the T6 has is a USB charging port.

The Freemax Starre fits perfectly on it. The Kanger Sub Tank is wider than the Sigelei but fits perfect on the T6.

Really enjoying both of these box mods.

A few pics
 

I only have this problem with one juice flavor. It has to be the juice. Same tank and setup as all my others. I have a fresh coil and tank, load it up, and in less than a day my coil is gunked up and turns my clear juice dark brown. Is this safe to vape? It's annoying having to finish it and rinse my coil. Usually I can just fill my tank/top it off without worrying about cleaning it all. Anyone else have this issue?  

So I decided to try a 1,6 ohm coil on kayfun v4 clone Tobecco and I am using 28gauge Kanthal with a cotton
wick on a Rdna 30 and its vaping well at 15 watts I have a kanger subtank mini coming in the mail and here goes my question
So the kanger subtank states that with a .5 ohm coil i could vape up to 30 watts but the voltage comes in at like 3.8 volts
I was under the impression that the rdna 30 needs at least 4 volts to work which kinda brings me to my second question
What is the point of of sub ohms? cant i just build a 2.0 ohm coil or something like that to achieve the results as if i was subohming
I am very confused on this
thanks for the replys in advance
Oh yea is a 1.6 ohm coil at 15 watts a normal build or any recommendations for the kayfun v4 for watts and ohms thanks again  

Just bought the Kangertech Subtank..... Was told I couldn't use my Max VG juice and I needed to buy some of their lower VG juice. I told the guy no thank you, I know what i'm doing and I can make it wick the Max VG.

Needless to say I got home, the STOCK OCC coil, .5 ohm, wicks my Max VG perfectly fine, even with chain vaping.

I ripped the pre-made coil out of the 1.2 ohm OCC head, and built my own .6 ohm coil in it, wicked it with Organic Cotton (Not KGD or Bacon, Just organic cotton from Walgreens) and it wicks perfectly fine with my Max VG.

I built a single coil .7 ohm spaced coil, wicked it with the double tails on each side, cut off to where it touches the deck, but not touching the threads, put the chimney cap on, and made sure the juice channel was free of blockage, and it wicks perfect with the Max VG.

No leaks, no dry hits, running each OCC head at 30 watts, and the RBA deck at 35 watts.

This is the original Subtank, 6ml for OCC and 4.2 for RBA, (NOT THE NEW 7.0mL version).

So let me hear it.... What have you guys noticed or seen about the wicking ideas, why has yours not worked?

WHY DO SO MANY PEOPLE SAY YOU CANT USE MAX VG ON RTA's, especially on the Kanger Subtank????  

I have the Subtank mini on a Kanger 20 watts mod and everytime my vape has been standing a while (specially the morning) and I take a hit, it is extremely harsh and I cough. After a a decent amount of hits it smooths out.

Is this normal?