How Many Watts Do You Vape At And What Is Your Build?

I've been using only twin-18650 mods for some time, and before the shipping ban came into effect, I bought a backup of my most-used mod (a Geekvape Aegis X), but since the 100W single 21700 / 18650 Voopoo Drag X Plus was only $35, I also picked up one of them as another backup.

I vape exclusively on RDA's, typically with a 3mm dual coil twisted build with 24 or 26 gauge Kanthal or nichrome-80. 5 or 6 wraps with 24 gauge, 6-8 wraps with 26 gauge. I typically vape these between 90 and 110 watts.

I did not expect to get a 'true' 90-100 watts out of the Drag X, so I set a target of around 60 watts. I mounted a 3mm dual coil twisted 28 gauge build with 6 wraps, which on my Aegis X vapes great at 60 watts, and very good at 50 watts. It measures at 0.45 ohms.

But on the Drag at 60 watts, it only vapes at what feels like 30 watts on my Aegis. Setting it higher makes no difference either, it seems to 'top out' at ~30 watts regardless of the setting. 60 watts @ 0.45 ohms is only around 11 amps, so I doubt I'm hitting an amperage limit.

I am using 18650 batteries (VTC5A), and it is about time to replace them, as I am only getting around 70% the battery life as I did when new. I will be picking up some 21700 batteries at the same time, which hopefully help with things on the Voopoo.

Does anybody have any good experiences with ~60 watt builds on a Drag X Plus?  

so in my pursuit of vaping above 200 Watts I made a fuse 3x24ga gauge wrapped with 36 gauge and I tried three coils. it came out .07 I Vaped it at about 375 watts it was a hot vape but the ohms were very low so I had a problem with power my DNA 250c was reporting 65 amp output so I took that and put in dual fuse 22ga gauge wrapped with 36 gauge I ran that build triple coil I used it at about 250 Watts. what I am trying to do is vape at about 300 to 400 watts with an ohm or .2 to .3. the inner diameter will be 5.5 or 5 mm I'll be using the kanthal core wrapped with 36 gauge and ni80.I'm trying to figure out what my next bill should be to try to vape above 300 watts the restrictions I have is it can't be below point 1 ohm or above .3 ohm I have two aromamizer plus has with the series deck The parallel deck a second parallel deck and a single coil deck. The single coil deck fit 6.36 mm.

I also have the aromamizer titan.

What gauge would you Clapton?

Sent from my HD1907 using Tapatalk  

Let's say one of the devices has a single coil 1.2 oh build .
Device 2 has let's say a .5 ohm build in it.

You set hour app to 30 watts on both devices and each applies different voltages to achieve this 30 watt of power.

However, my question mor to do with practicality. What if any differences will you notice vaping wise ? From my experience they clearly don't vape the same which could have a lot to do with slight difference in airflow as well as difference in wick and the wetness of the wick and the list goes on. But if somehow could take those factors into account how would these vape ? The exact same ? I tend to think not but I don't know the reasons why.

Can someone give me your input or help me devise a better question to ask.

Many thanks.


Sent from my iPad using Tapatalk  

What is your go to single coil build in terms of gauge wire, diameter, and number of wraps : (no fancy Clapton or twisted build just a "regular" wrap)

And if you have a reason please include it: For example: "I'm a flavor junkie and this is best flavor build I've found" or "I like short ramp up times" etc ...

(I know preferences may vary greatly)

Thank you very much

:


Sent from my iPad using Tapatalk  

I'm going through a ton of stress at my job and recently began vaping ALOT more than I normally would, in two days I went through a 30mL bottle (not sure if that's a lot for some of you, but for me it is!)

about five days ago I woke up and my throat was EXTREMELY sore, extreme strep throat sore. For several days I could hardly talk and had excessive coughing spurts every 15-30 minutes. It's finally calmed down, last night I smoked a few cigarettes and had no discomfort in my throat, but I picked up my vape and tried to take a hit and the pain cannot be described. Today the same thing, I had a cigarette and was fine but when I go to hit my vape it's just unreal how bad the pain is in the back of my throat.

I know some people can have a bad reaction to the PG but I've been vaping for three + years and never had this type of problem. Has anyone else had this experience? Should i let my throat heal a little more before vaping? I just don't understand how a cigarette can be fine and the pain from the vape be so much.  

Ok I'm hoping I don't get heat for these questions/statements but educating ones self especially with something that is still very new is important to me.

1. Read some articles on how there is second hand vape similar to cigarettes (99% better mind you) what are your thoughts? Vaping may not be as safe as smokers think, research suggests | Society | The Guardian

2. Formaldehyde found in builds running at high watts/voltage? But 0% at low/normal builds, what i can't seem to find is whats considered to high for a Mechanical Mod or even for a V/W, V/V Setup? My normal build for a mech mod is twisted single coil 24 gauge 6-7 wraps, usually gets about 0.28 ohms and single coil 8 wraps of 24 gauge puts out 0.73 ohms on my flavor builds.
Before You Vape: High levels of Formaldehyde Hidden in E-Cigs - NBC News  

Hello, I have been vaping for years, at 1.8 nic strength. I have some questions.

First of all I think I've made a problem by vaping on (all kangertech devices and coils), at .5 ohms, but I only vape at 20-24 watts. Is this wrong? Anything higher is way too hot, and I just don't enjoy it. I've bought a smok mag and other devices that wont fire under anything 50 watts and it was way too strong so I never use it.

Also, over the past 6 months I've developed some mouth sores I'm pretty sure it is
Tobacco Stomatitis
I know this is from vaping or smoking, the heat I guess is causing this. I've told my dr. about this he never really looked (I was in for something different than this), he replied try to vape point it downwards towards my tongue and I have been doing this for months, but to no avail with the mouth sores going away.

I can't quick vaping. I tried for a few days and I smoked more cigarettes than I ever did. It was actually hotter I noticed. I still smoke cigarettes when I drive, just a weird habit and at work on breaks. I vape all day at work when my boss isn't around.

I'm going to stick to just the unflavored e juice from now on. I'm also cutting the strength back. I also tried cutting it before with 0% percent e juice and to no avail my mouth sores are still there.

Sorry for the diatribe but I just have a few questions.



Does smoking at 22 watts and sometimes below with sub ohm coils, is this bad? I've been doing it for years now. The problem is I bought a ton and I find it hard to find coils now over 1 ohm. It seems all they sell not days is .5 coils. And I've tried nickel and and they just burn in a day, even with the settings they are supposed to be at, so I'm really at a loss as to what to do.

Also has anyone else experienced the tobacco stomatitis as I have?  

So I decided to try a 1,6 ohm coil on kayfun v4 clone Tobecco and I am using 28gauge Kanthal with a cotton
wick on a Rdna 30 and its vaping well at 15 watts I have a kanger subtank mini coming in the mail and here goes my question
So the kanger subtank states that with a .5 ohm coil i could vape up to 30 watts but the voltage comes in at like 3.8 volts
I was under the impression that the rdna 30 needs at least 4 volts to work which kinda brings me to my second question
What is the point of of sub ohms? cant i just build a 2.0 ohm coil or something like that to achieve the results as if i was subohming
I am very confused on this
thanks for the replys in advance
Oh yea is a 1.6 ohm coil at 15 watts a normal build or any recommendations for the kayfun v4 for watts and ohms thanks again  

anyone know of one that exists? I want a box mod that can go up to 100-150 watts but want one that has internal batteries that I can charge via usb cable or ac adapter

I was looking at the segelei and ipv3/4 but I don't want to change batteries

the reason is I travel sometimes for my job up to 2-3 hours and I don't want the hassle or danger of changing batteries while driving
I want something I can vape on for a couple hours without worrying about replacing the batteries

I sub ohm at .2 ohms and bought the arctic tank .2 ohm coils specifically for this reason

thank you

p.s. I found this: MEGATRON 260 watts 5400mAh box mod uses ac adapter to charge but looks really weird and no one has tried it yet so I'm a tad skeptical  

I have been out of the game for a while and have just been using old mods/RTA's.

I am looking for suggestions on some of the best up to date mods as well as some of the best RTA that go with the mods.

Here is a little info...I usually vape at around 30-35 watts...

For the mod, I am looking for one that takes a single 1865 battery, is small in size, and is lightweight.

For the RTA, I am looking for a single coil DL tank....one that can hold at least 5ml of juice, can go with the mod suggested, and provides great flavor.

Can you guys please give me some suggestions? Thanks a lot