E Cig Works Fine For About 5 Minutes Then Goes Burnt

I've got one that has me puzzled. I went through two fills of my Aerotank V2 with Cosmic Fog's Milk and Honey when it started to taste burnt. I figured no big deal, let me change the coil and clean the tank and all will be well. Well, new coil and cleaned tank and about 4 drags in it tastes burnt again. Thinking maybe I have a bum coil I try another one. Same deal.
I'm at a loss. It's the same bottle of liquid, same tank (cleaned each time), same battery (iStick 50w), same wattage (8.9), same resistance (1.2 ohm). Anyone have any clue what's could be causing this? It's getting expensive in coils and liquid!

Thanks  

Think i might of burnt out a Alantis coil yesterday, still not sure. I stuck my tank in cup of hot water for 20 mins with 1 or 2 drops of washing up liquid. Then i dried burn the coil.

When assembling my tank and topping up with new juice i got a horrible burnt taste so i just swapped it out and put a new coil in. At the moment i only got 1 sub ohm tank and i i got a selection of juices. I do intend to get another sub set up waiting on ZNA 50 as i type this. But this going to take time as i went for the cheapest option ie Fast Tech.

Does anyone know how long the coils for Alantis tanks are suppose to last ? and the best way to keep them clean when swapping out juices ?

Any advice would be really helpful.  

Hello everyone. I am new to the forum but I have read a few more topics before having to create an account and explain my problem in detail. I own a Geekvape Aegis Mini TC 80W (with the Cerberus tank) and I'm using a 50% / 50% e-liquid, with chocolate, coconut and oats from Nebula. I have owned it for about 2 weeks now. I've been using a .3 ohms coil in these weeks, and I've been really good, except for the last 2 days, I've burned the coil slightly and I don't like the taste anymore, so I decided to switch to the other .2 ohms that I've bought a couple of days ago, so I primed the coil by putting 4 drips in each cotton hole + 2 or 3 drips in the center cotton (it's a mesh coil). I forgot to say that I vape mainly from 30-40watts but it's fine even from 25-42W, I'll never go over it because only the noise scares me. Yes, I know, it's weird. Anyway, my problem is that after switching to a .2ohms coil (it's been about 30 minutes) at 30watts the taste is yucky, totally different, I wouldn't say burnt but not good, plus the noise is like it's muffled, yeah , I opened the holes, if I go over 30 watts the noise gets slightly louder but the taste worse. I would just like to know if I have to leave it overnight to let the liquid absorb well or change the coil directly because it is faulty (I have another 5 of .2ohms but no other so I can't go back to .3ohms)
So, is this normal?  

Im new to external battery mods but have been vaping for 3 years and I know how to prime a coil with e-juice. I go the extra mile after I prime the coil and let it sit for a minute. Then I fill up the tank put it back together and do not touch it for at least an hour or two just to make sure. I just got my now verified as legit sigelei sobra with the moonshot 120 both of the coils from that taste like those knock off BS eBay fake coils. I started off at a very low wattage and I don't know what's wrong both coils are disgusting. It's not exactly a burnt taste or a dry taste it's like a sour off taste and I can't use them. It also makes me feel like I have something in the back of my throat. What in the heck is going on? Do these coils take awhile to become usable? They're the coils that came with the mod and I verified the mod so I assume the coils are also okay. I even went so far as to try the second coil on a different mod but with the same tank just in case the mod was frying things the very first hit. Can anyone give me an idea of what's going on so I know what I need to do and also if anyone could tell me whether or not the Cascade baby coils will fit in the moonshot 120  

My first .5 OCC coil only lasted 3 days . I put my device up to 25 watts and it totally fried it. A terrible burnt hit. I backed it back down to 20 watts and it was fine for a little while, but then another bad burnt hit. Down to 15 watts and I literally sucked hot particles in my mouth when taking a hit. ...? The cotton and/or coils are literally breaking apart? That's totally gross and I can only imagine, not that safe.

My second .5 OCC, I never put my device above 17 watts, keeping it at 15 watts for the most part. Within 4 days, same thing ... total burnt hit one day, sucking up hot particles the next?

What's going on? I thought I was supposed to be able to hit a .5 coil up to 30 watts ... Is sucking up hot particles from the coil normal? Should I just keep it at 12 to 15 watts and that's it, taking 1 to 2 second drags and that's it? Is it just a string of bad coils?

Thanks

EDIT: Thought I should mention that the juice I used for both coils was 50/50 watermelon. I hear it's better to use higher VG liquids with sub ohm tanks. But can that be part of the reason why the coils are being fried so quickly?  

Hello everyone,

I'm vaping with a Vaporesso Swag and have tested the GT2, GT4, Mesh and Ccell coils so far. I'm vaping 50/50 VG/PG liquid with 3ml/mg nicotine. I always use the coils at the lowest recommended wattage, airflow fully open and my puffs are usually 2 seconds long at max.
Now my problem, I'm going through coils faster than others change their underwear. I'm on my third coil now for 10ml (!) of liquid.
I prime my coils and I let them sit in the tank for at least 30 minutes before I use them. I get muted flavor after maybe 5ml of liquid and it tastes burnt after 10ml of liquid. I've also tried different liquid brands and at least 20 different flavors.
So what am I doing wrong? I'm about to quit vaping because of the immense cost of coils I go through. I just can't figure out what I'm doing wrong.  

Hey there guys, new here.

I have a Vappresso Revenger Mini kit and I have upgraded my tank from NRG SE Mini tank to a "Geekvape Z Sub Ohm tank(Much Larger Tank)". Because I wanted to taste more flavor and still blow lots of clouds in the air with my vaping device being fairly cheap.
I put a New Geekvape Z series coil 0.4ohm 50-60W because I burnt my original 0.2 Ohm coil , I wont talk about my previous coil. I'm getting 2 problems here.

1. I'm using 60W, normal setting and every time I vape or inhale I get a taste of E-Liquid in my mouth. However its blowing perfect clouds and still getting an amazing taste but its just that the liquid drops in my mouth. I just want to spit it out every time. How do I fix that problem?

2. The other thing is if I use Higher Wattage and High settings the liquid pours out of the air flow and starts leaking and backspits in my mouth.

(Before I vaped with new coil)I put the new coil in, I soaked it for 10-15mins, while I fill half tank of E-liquid which is 0.8Ng/0.2PG. Then I inhaled 3-4x with no button pressed. Then I vaped to test, still leaking. I set the vape to 70W and high setting then blow downwards into the device 5-6x. All I was trying to do is desaturate it. My results got better didnt notice much of a leak but I still get a little bit of liquid in my mouth. If you can help me out here, I would much appreciate it.

Thank you and kind regards

Tuatara Vaper  

Uhh...so idk what it is,tasting burnt no matter what ,new coils ...two different rba pieces for subtank mini...guys at local vape shop didn't taste it but I notice a flavor of burnt n not juice...tht was hours ago,just tried again few mins ago and not burnt,but why would it be like tht? If a bit more cotton would it b better? But then I get juice...less cotton I get odd taste...I can't win lol idea on y it's like tht? Rba's r both fine.  

Hi I am a new user to vaping I want to know if the coil is burnt beacuse it seems black inside. Is it possible to know seeing outside if it is burnt? the coil is 0.5 ohm euc (veco tank) and the taste seems to be nothing ...  

So I purchased the eGo One after hearing amazing reviews of the device. I use an Aspire Atlantis on an MVP 3 but needed something more portable for work/going out. I was more than impressed with the eGo One using the .5 ohm coil, and equally so with the 1 ohm coil. The battery life is great, the flavour is perfect and the vapor production is unexpected. However, within 2 hours of using the .5ohm coil, the vapor began to taste burnt, more than on any other wick I have burnt. So until I could get hold of another I used the 1 ohm coil. 24 hours that one lasted. Joyetech said they would send me replacements free of charge, but while waiting for this I went to my local shop and bought another .5 coil. 1 HOUR LATER, it's frazzled. Wether I'm just being unlucky or the device is faulty I don't know, but I am incredibly disappointed. It's not through a lack of priming or using the wrong liquid, I'm an experienced vaper and had fully primed the wicks for 20minutes minimum and was using a 50/50 juice. This device had great potential, but it will be going in the bin for now (except the battery, which even does a great job on my Atlantis)