I Got The Impression Tc Is Unpopular - But Why?

I’m a mouth to lung vapor and currently using the holic rda and galaxies rdta. I’ve tried using ni80 round wire and superfine mtl fused Clapton ni80 wire. The round wire is so easy to work with and the superfine is harder but I’m getting the hang of it. My question is with coils that ohm out the same with each wire I get flat flavor with the round wire and the flavor definitely pops with the fused Clapton wire. Is this normal? Same juice, same wattage, same ohms and same rda and squonk.
I love working with the round wire but not worth it if I can’t get better flavor.  

I caMe home from work and seen my topside single was lit up on my dresser.I hadn’t used it in a couple days so I picked it up only to see that the wattage is going down non stop and won’t fire and it’s as if the wattage down button is stuck. It’s not though. I can’t find anything small enough to take the panel off so I pretty mad. Only
I’ve had Mabye 40 refills with this mod and never been dropped . Just use it on the weekends when I drive mainly that’s it . This is why I hate regulated mods. Anyone else have this problem? I don’t know why it doesn’t even come with a Alan key to
Take it apart.  

First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.

Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.

I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.

I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.

I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.

I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.

I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).

Can someone provide me more insight?

Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?

I use TC at 420F 20 watts


Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping  

With everything going on in the vaping world I was wondering if we’ll still be able to buy PG/VG premixed.
I buy premix PG/VG with nicotine already added so I’m wondering if I should buy 4 or 5 gallons to make sure I can get it.
Also I was told that if I buy a few gallons that I should freeze it or refrigerate it,is that right?
I sell mods and tanks so I have plenty to last years because I use to sell them on ebay until they ban selling them on the site.
I’m on private sights but don’t know what’s going to happen after April.
I live in New York so we already are have a juice ban so I mail it to a friend in another state and they forward it to me.
Now I’m buying premix so I can just flavor my own juice but I’m worried they might stop shipping premix PG/VG and then what will we do?
So any information on what’s ahead I’d appreciate your information. I’m new so I’m trying to learn how to find information on here.
Thank You  

I’m curious as to why you shouldn’t do DL when using nic salts. I’ve got an Aegis Hero with a 0.6 coil at 15 watts. Even with the airflow closed off, it’s still to loose for a MTL. I keep reading and hearing I shouldn’t use nic salts for DL. The worst thing I’ve experienced so far is a mild headache. The nic salt is a 30mg.
Thanks in advance. ECF is my only true support group and I’m having a really hard time not smoking the stinkiest. Been back to vaping for about a month, and keep telling myself it’s all about baby steps. Not how many I smoke but how many I don’t smoke. I’ve got to quit for health reasons.  

I managed to wick a coil properly with rayon and got amazing flavor, but since then, I just can’t get the right amount of wick.

I can’t find any videos about how to do it starting from that fat roll that it comes in. I know it’s supposed to make that squeaking noise, but it’s eluding me. I generally cut it in half and then just eyeball the width and trim. Is there an easier way to do this for my 2.5ID coils that will get me a better wick, or am I doing it right?  

Hey guys I’ve been enjoying vaping for a few months now and I’m loving it.
I’ve learnt how to fix some leaks and backspits so I am happy with that .
But I have washed one of my coil cleaning it under tap water and left it to air out for a week cuz I used another coil at this time.


I’m not getting much juice and the cotton in the coil is quite hard. So I’m sucking mostly Heat vape
But it’s not terrible or anything?

What should I do ?

Kind regards  

Hey everyone! So it’s clear that things are changing for all of you who live in the USA. I truly feel for all of you, and I still can’t believe this is happening. But, what is the impact that this is going to have in all of the other countries that basically depend on the US market?

I live in Perú and in most shops, if not in all of them, most of the juice that is sold is directly imported from the USA. Does this mean that we won’t be able to purchase these items anymore either? And what about new devices? I’m aware that most of them are made in China but under American brands.

I understand that the USA has probably been one of the biggest markets in regards to vaping. How is this whole thing going to impact the rest of the world? Our vape community isn’t that big, it just started growing last year. Stores don’t really make their own e-juices, it’s hard to get good quality ingredients.

I’d really appreciate your thoughts <3  

I’ve been away from vaping for about 7 yrs. I don’t have any of my old equipment, which now I miss very much. I’ve been trying to get back to vaping for health reasons, and having to learn all over again. Everything is dual coil. I NEVER used dual coil, but I’m trying to learn. I got a Vaporesso PM40, a Drag S a hcigar vt inbox and a POS squonker that I’m using for a dripper (reviews said they leak and short out causing me to fire by their self. I joy cappo squonk box).
Do I figure dual coil watts and amps like I did my single coil builds. I never got into the low sub-ohm thing. Maybe 0.9-1 ohm.
It’s good to be back in ECF again.  

Dear forum!

here goes my strange experience:
I’ve been coiling and wicking for years pretty much the same way, and it was kinda ok = I adapted to all the quirks I had.

Recently I built a new coil, but instead of 4mm I decided to make 3.5mm coil. Same wraps number.
Wicked it as I alway do - exact same material, thickness (adjusted to coil diameter of cores) trimming etc.

And wow!
No problem with TC now!
Works reliably, no leakage, I can chain wape the whole tank!

could this one Change in coil diameter choice did the trick???

Or is it a fluke? (Well I’ll find out when I’ll built next coil same way...but still)

best regards
Vadim